Lenox Laser Flow Certifications

Our methods of testing and calculating are new and unique. Our testing methods and our calculating methods will be described in a three page description included with this explanation.

Basically all test methods described depend on comparing a part being tested to one of our standards. We have over one-hundred standards which were developed by test method number one. While developing standards a certified digital test gauge that reads in absolute pressures was used to establish and maintain 29.7 P.S.I.A. To establish water volume in the tube or tubes between the lower and upper photocells, water was carefully poured into the system (using an eye dropper), until the lower light came on. Further water was added until the upper light came on. The water added was measured in graduate cylinders and also weighed on a digital scale that read to the thousand of a gram. These volumes with the computer measured time to go from the lower to the upper photocell provided the information to calculate the flow rates and the flow diameters. All tests to establish standards were run a minimum of five times.

In the past, we have sent a few standards to N.I.S.T. test facility for comparison. The first few were midsized and compared within ½ of a percent. The next time we sent some near 5 microns in size and they were found to be approximately ten percent to large. We then sent the same orifices to another N.I.S.T. test facility and they found them to be approximately ten percent too small. They guarantee their test to be within plus or minus seven percent.

We have many repeat customers that have found our work satisfactory over the years. Some of these customers are large and have very sophisticated test equipment of their own. Among these customers is Sandia who gives our quality system an SPQR 1050 certified rating.

All of our standards are re-calibrated yearly. When calibrating parts for customers two separate standards are use to orient the computer. If there is any discrepancy, further testing and checking follows to determine the cause of the problem.
A Lenox Laser certification means we have tested your parts to meet our standards and procedure.

If you need further approval, you can purchase the orifices needed and send them the test facility of your choice.

For more Flow Calibration Certification services, please visit Lenox Lasers certification page.

Drilling and Flow Calibrating Small Holes Down to One Micron in Diameter
Test Components with NIST Traceability